Fire With Oven; Fire With Ventilator; Fire With Central Heating Connection - Dik Geurts Noa Medium Mode D'emploi

U SE R MA N U A L
- if the fire is not burning properly, you can temporarily open the slide of the air supply further;
- do not only use soft wood, but mix it with hard wood in particular..
Ø
Refill the fire before the flames have gone out of the fire. This will be approximately every 30 to 45 minutes.
Ø
Always allow the fire to burn empty when you stop burning.
Smoke
Light coloured (white or colourless) smoke indicates that suitable wood is used and that there is a good
combustion. Grey, blue or even black smoke is created in case of incomplete combustion, e.g. as a result of moist or
excess wood.

5.4 Fire with oven

If your fire is provided with an oven, you can use it to heat or cook dishes.
You can close the oven, using the valve (see Appendix 2, Fig. 5 (K)). You will usually suspend it at the side of the fire,
because air for glass pane aeration is supplied by the oven. Use the oven glove for this.
When used, you must always place aluminium foil in the oven in order to avoid fat from getting on the oven surface
and burning into it. Only use the oven after the fire's paint has hardened (see section 4.1).

5.5 Fire with ventilator

In the installation manual, which is supplied separately with the fire, the operation of the ventilator is explained.
Extending your appliance with the ventilator will increase your comfort, as your room will be heated more quickly.
After it has been switched on, you can sense a warm air flow. The system can be ajdusted to both a low and high
setting.
5.5.1 Operation
In the corner below the closing handle you will find the switch to operate the ventilator (see Appendix 2, fig. 6).
The switch has a high and low position.
After switching on, it will take some time before you sense the warm air flow. This is because the air flow will only
start going once the appliance is sufficiently warm. The ventilator is controlled by a temperature switch and will be
activated automatically. After the appliance has cooled down, the ventilator will switch off automatically.
The ventilator must always be connected to a 230 V connection, otherwise the ventilator may get damaged as a
result of overheating.

5.6 Fire with central heating connection

In the installation/user manual, which is supplied separately with the fire, the operation of the fire with the central
heating connection is explained.
(if applicable)
UK