Environmental Protection - Garland 790 G Manuel D'instructions

31 | English
STORAGE
- When storing engine for more than 30 days:
a. Store in a dry and clean area.
b. Run engine until fuel tank is empty and engine
stops or add gasoline preservative and running
engine after adding for several minutes to circulate
preservative.
1. Place the chipper/shredder in a dry, level area.
If the chipper/shredder is tipped it may leak oil
and gas.
2. Drain all the fuel from the fuel tank and the
carburetor ensure that all the fuel has been
removed.
3. Change engine lubrication oil if necessary.
4. Clean exterior surfaces of the engine.
5. Do not store the chipper/shredder near an ignition
source, such as wood stove, gas or electric heater,
or an appliance or heater with a pilot light.
6. Remove the spark plug wire to prevent
unauthorized starting.
7. Store the chipper/shredder in a well ventilated
area.
DO NOT store the chipper/shredder in an area that
will allow toxic gas fumes into areas inhabited by
humans or animals.
8. Close the discharge chute defl ector and place the
covers over the hopper and the funnel to prevent
objects or critters from getting into the machine.
9. Cover engine well to prevent dust.
10. Keep the tool away from children.
- When the machine is stopped for servicing,
inspection, or storage, or to change an accesory,
shut off the power surce, disconnect the spark
plug wire from the spark, make sure that all
moving parts have come to a complete stop. Allow
the machine to cool before making any inspections,
adjustments, etc.
- Store the machine where fuel vapour will not reach
an open fl ame or spark. For extended storage
periods, run the unit dry of fuel. Always allow the
machine to cool before storing.
- When servicing the cutting means be aware that,
even though the power source will not start due to
the interlock feature of the guard, the cutting
means can still be moved by a manual starting
mechanism.

ENVIRONMENTAL PROTECTION

- If the machine turns usefulness someday or are no
longer needed, it should be discarded under any
circumstances, household waste, but recycled
organically.
- The machine must be delivered to authorized
recycling point. The pieces of plastic and metal can
thus be separated there and reused in the
production chain.
Information on recycling can be obtained from the
administrations of the respective communities or
neighbourhoods.
- Used oil is a hazardous waste product. It is
suggested to bring used oil to your local recycling
centre with properly sealed container a sealed
container to your local recycling centre. DO not
discard with household waste.