Garland GAS 159 E Manuel D'instructions page 32

English
3. Insert the tube to the air outlet of the engine as far
as you can " " .
3. Rotate following the groove until you reach the
locking position. Once you have done this, you
must be blocked to fix the tube.
4. Insert the tube of the sack to the air outlet of the
engine as far as you can (A) and f asten to the
aspiration tube (b).
A
B
6.3. START UP
ATTENTION: The machine does not work if not fully
mounted.
6.3.1. CHECKING POINTS PRIOR TO USING THE
MACHINE
The current and tension supplied must coincide with
those in the characteristics label. Prior to starting
work check that the machine works adequately and all
security measures work.
Do not use the machine if it is damaged or not well
regulated.
Use this machine to do jobs for which it has been
designed. Any other use could be dangerous to the
end user, for the machine and to other people, animals
and things that are nearby.
Check that the machine is correctly mounted with both
tubes and the catcher.
Verify that:
- The machine completely and look for loose parts
(screws, nuts, etc.) and damages.
- Press, repair or replace everything you need before
using the machine
6.3.2. FIXING CABLE EXTENSION
Only use cable extensions that are homologated for
outdoor use.
The cable section must be at least 1.5mm and the
cable extension should never be longer than 25m and
must be completely unrolled before starting to work.
Fix the cable by inserting it on the hook provided to
this effect at the back of the machine.
32/100