Auto Brew Delay; Before Brewing - Black & Decker SPACEMAKER SCM200BD Guide D'utilisation Et D'entretien

AC TI VATI N G THE AUTO BREW D ELAY
1. Ensure the Auto Brew delay time has been set
(see "SETTING THE AUTO BREW DELAY" section for assistance).
2 Press the AUTO button once. The word "AUTO" will appear and the
LED light above the AUTO button will illuminate.
3. When Auto Brew is activated, be sure to have both coffee
grounds and water in your coffeemaker. When the time of day
and programmed Auto Brew time match, your coffeemaker will
automatically brew a fresh pot of coffee.
4. To deactivate Auto Brew, press the AUTO button again. The AUTO
icon and light will disappear will turn off.
Note: If the unit is unplugged or power is interrupted, the digital clock
and Auto Brew settings will need to be reprogrammed.
BE FO R E B R EWI N G
• Clean all removable parts of your coffeemaker in warm, soapy water.
Rinse and dry these parts prior to placing them back into your
coffeemaker.
• To remove any remaining dust or residue from the manufacturing
process, run two full brewing cycles using only water, no coffee.
• Make sure your coffeemaker is plugged in. The water reservoir
light will be illuminated and remain on as long as the appliance
is plugged in.
• Remove the integrated water reservoir and fill with fresh, cool
water. Replace water reservoir into coffeemaker. Be sure it snaps
into place securely.
• Remove the brew basket and place an empty 8-12 cup basket
style paper filter into it. Do not add coffee grounds. Replace
brew basket. Be sure it snaps into place securely.
• Place brew-through lid on empty carafe. Coffee may overflow if
brew-through lid is not properly aligned.
• Insert carafe securely along slots of carafe holder. Ensure carafe
is fully inserted.
• Press the On/Off button to start the brew cycle.
• Once the brew cycle is finished, discard the water from the
carafe as well as the paper filter from brew basket.
• Turn off appliance, unplug and allow unit to cool for 15 minutes
before repeating.
11