Publicité
Les langues disponibles
Les langues disponibles
BREWING COFFEE
1.
Open cover.
2.
Fill water reservoir with desired amount of water. The 12 line on the side
of the reservoir represents a full carafe of coffee. Do not fill past this 12
Cup line.
Note: Use spring water or filtered water. Distilled water lacks the minerals
necessary to bind to elements of coffee.
Note: Filtered water will limit impurities and excessive minerals that can
detrimentally impact coffee flavor and machine performance.
3.
Insert a basket type paper filter into the brew basket.
4.
Add desired amount of ground coffee. Close lid, making sure it clicks.
5.
Make sure carafe lid is properly attached to the empty carafe. Close the
carafe lid.
Note: Coffee may overflow if carafe lid is not properly placed.
6.
Place empty carafe on the carafe plate.
7.
If not already plugged in, plug power cord into an outlet.
8.
If regular brew strength is desired, your coffeemaker is set to brew coffee.
9.
If strong coffee is desired, press the STRONG button once to select
the strong brew. The LED light in the display next to STRONG will
illuminate. To turn STRONG mode off press the STRONG button again
and the LED light will turn off.
Note: We recommend using the STRONG setting to ensure the best flavor
whenever brewing 4 cups of coffee or less.
10. Press ON/OFF ( ) button and brewing begins. The ( ) button
illuminates while brewing.
11. Once coffee grounds have cooled, carefully open cover and, discard
used grounds. Close cover.
12. The coffeemaker will keep brewed coffee hot for 2 hours and then
automatically turn off.
To turn off the coffeemaker at any time press the ON/OFF button ( ). The
ON/OFF ( ) light goes off.
SNEAK-A-CUP
FEATURE
®
Remove the carafe and brewing is paused. The carafe must be placed back
on the carafe plate in 30 seconds to prevent overflow. Brewing begins again.
KEEP WARM FUNCTION
The hot plate remains in "keep warm" mode for 2 hours (120 minutes)
following the brew cycle.
•
During this time the ON/OFF ( ) button remains illuminated.
•
After 2 hours have passed, the heater turns off and the ON/OFF ( )
light turns off.
To turn off the coffeemaker at any time press the ON/OFF button ( ).
6
BREW LATER FUNCTION
If BREW LATER function has not been previously set:
1.
Press the BREW LATER button.
2.
The LED light in the display next to BREW LATER illuminates and
flashes once per second.
3.
Clock shows last BREW LATER time programmed (if no time has been
programmed, or unit has been unplugged, BREW LATER time defaults
to 12:00 a.m.).
4.
Use HOUR and MIN buttons to set BREW LATER time (while BREW
LATER in display is blinking).
5.
Press the BREW LATER button again to set the BREW LATER time.
Or, the coffeemaker will automatically set itself after 4 seconds with no
button pressed.
6.
The unit will begin brewing at the BREW LATER time.
If BREW LATER function is already set:
1.
Press BREW LATER button to check the BREW LATER time. The
clock will flash once per second and display the BREW LATER time
for 4 seconds. At this point, you may reset the BREW LATER setting if
desired.
2.
To cancel the BREW LATER function; press and hold the "BREW
LATER" button for 3 seconds.
3.
Four seconds after you stop pressing buttons, the clock reverts to
current time.
Note: Even though BREW LATER is disabled, the BREW LATER time will still
be stored unless unit is unplugged.
CARE AND CLEANING
This product contains no user serviceable parts. Refer service to qualified
service personnel.
CLEANING
• Be sure the unit is unplugged and has cooled.
• Wash the removable parts in the top rack of the dishwasher or wash by
hand in hot water with dish detergent.
• Wipe the appliance's exterior surface, control panel and carafe plate with
a soft damp cloth. Do not use abrasive cleansers or scouring pads. Never
immerse the coffeemaker in water.
• To clean the inside of the cover, open the cover and leave in the open
position. Wipe surfaces with a damp cloth.
7
Publicité
Chapitres
Dépannage
