Whirlpool HGL 44 A Manuel D'instructions page 28

OPTIONAL
Detergent Adj.
Filling Phase 7,7 ml
Washing Phase 19,3 ml 25s
Test: press START
Brightener Adj.
Filling Phase 3,1 ml
Rinsing Pahse 7,3 ml
Test: press START
1/2
Detergent adj. (optional)
Filling Phase: adjusts the amount of detergent in the filling phase of the
10s
dishwasher (ml/s)
Washing Phases: Adjust the amount of washing detergent established (ml/s)
Test press: by pressing continuously
on going.
2/2
Brightener adj. (optional)
Filling Phase: adjusts the amount of rinse aid in the filling phase of the
15s
dishwasher (ml/s)
35s
Rinsing Phases: Adjust the amount of rinse aid established (ml/s)
Test press: by pressing continuously
on going.
9 – ERRORS DISPLAYED/PROBLEMS
DISHWASHER WITH BUILT-IN OSMOSIS SYSTEM
REPLACING THE CARTRIDGE FILTER OR THE MEMBRANE
It points out that the carbon or mesh filter installed upstream from the dishwasher or the internal
membrane has reached the end of its service life.
Warning: the cartridge filter protects the internal membrane. If it is not replaed in good time, the
membrane will deteriorate irreparably.
the detergent dispenser is activated
the rinse aid dispenser is activated
Boiler/tank not filled within the set time.
SOLUTIONS:
- Make sure the overflow is fitted properly in place (if there is
one).
- Check the mains water inlet.
- Press the START button (red) to reset the count.
- If the problem persists after switching off and on again, call
the technical assistance service and inform them of the type
of error on the display.
Anomaly or beakage of the temperature probes of the
boiler/tank.
SOLUTIONS:
- Switch off and on again.
- If the problem persists after switching off and on again, call
the technical assistance service and inform them of the type
of error on the display.
28