First Time Start-Up; Preparing For Use; Operational Instructions - Whirlpool HGL 44 A Manuel D'instructions

supply cable (not supplied) and the socket in the wall
If wash pump is three-phase check that the direction of rotation is that indicated by the arrow on the motor. If not,
invert the phases L1 and L2 , or L3 with L2 or L3 with L1
REPLACING THE CARTRIDGE FILTER (version with osmosis).
This symbol points out that the carbon or mesh filter installed upstream from the dishwasher has reached the end of
its service life. Proceed as follows:
Switch off the dishwasher and disconnect it from the mains.
-
- Shut off the water inlet cock.
- Using the spanner supplied, unscrew the ring nut.
Remove the carbon or mesh filter and drain the water from the filter holder.
-
Fit the new filter in the holder.
-
Put the filter holder back in place and tighten the ring nut using the spanner supplied.
-
- Open the water supply again and make sure there are no leaks.
- Connect the mains and switch the dishwasher on.
Access the menu and reset the filter count.
-
The electrical protection system must be put through a functional test before starting up the appliance. It must be installed
and/or checked by the authorized retailer who will start it up for the first time and provide instructions on how the dishwasher
works.

PREPARING FOR USE

The rinse aid dispenser is always installed, but the detergent dispenser only on some models.
If both dispensers are installed, put the external detergent and rinse aid containers in place and insert the priming pipes
(situated at the back of the machine) into them accordingly.
Red pipe: detergent / clear pipe: rinse aid.
Before inserting the pipes into the containers, fit the weight at the ends so that they stay at the bottom of the container and also
the filter, as indicated in fig. 2. To adjust, turn the adjustment screws, as shown in fig. 1-3; you are recommended to have the
adjustment done by personnel of the detergent suppliers.
If the detergent dispenser is not pre-fitted, it can be installed later by ordering the related KIT (contact the technical service).
Dishwashers without detergent dispenser: put the detergent directly into the tank every 4-5 cycles approximately; for the type
and quantity to use, follow the instructions given by the detergent supplier.
Use exclusively detergents and rinse aids for industrial dishwashers. Do not use normal detergents for dishwashing by hand.
You are recommended to use exclusively products that have been studied specifically for this dishwasher.
Make sure not to mix up the detergent and rinse aid containers when topping them up, as the wrong product in the
wrong container could cause malfunctioning and could damage the dishwasher.
Do not mix different detergents, as this could damage the dispensing device. Detergents for industrial dishwashers can
cause serious irritations. Follow the instructions of the detergent supplier written on the package.
Open the
the level of
mains water
detergent and rinse
cock (utility).
aid in the
containers.
5 – FIRST TIME START-UP
6 – OPERATIONAL INSTRUCTIONS
Check:
that the filters are in the correct position, the spray arms
turn and that there are no foreign bodies in the
dishwasher.
Switch the main
ON/OFF switch on
(utility)
22