Whirlpool HGL 44 A Manuel D'instructions page 29

PROBLEM
THE MAINS LIGHT FAILS TO SWITCH
ON
THE WASH CYCLE FAILS TO START
POOR WASHING RESULTS
INSUFFICIENT RINSING
THE GLASSES AND CUTLERY ARE
STAINED
WATER IN TANK AFTER DRAINING
High water level in the tank.
When this message is displayed, the filling and rinsing solenoid valve does not activate.
SOLUTIONS:
- Check if there are any obstructions in the drain pipe.
- Check if the drain pump is working correctly.
- Switch off and drain the tank. Switch on again.
- If the problem persists after switching off and on again, call the technical assistance service
and inform them of the type of error on the display.
POSSIBLE CAUSE
Mains not connected
The dishwasher has still not filled.
The holes of the spray arms are
clogged or scale is obstructing
them.
Not enough
detergent or rinse aid
Plates/glasses
correctly.
Too low wash temperature
The set cycle is unsuitable
The spray nozzles are clogged.
Scale in boiler.
The rinse aid is unsuitable or is
not dispensed correctly.
Water hardness above 12°dF or
high dissolved salt content.
The drain pipe is not positioned
correctly or is partially obstructed.
POSSIBLE SOLUTION
Check the electric mains connection.
Wait for the triangular Led to switch on.
Dismantle and clean the spray arms.
or unsuitable
Check the type and quantity of detergent.
not positioned
Arrange the plates/glasses correctly.
Check the temperature on the display; if it is
below 50°, call the technical assistance
service.
Increase the wash cycle duration, especially if
the crockery/cutlery is particularly dirty or there
are stubborn leftovers to clean.
Check if the nozzles are clean and if the
softener (if installed) works correctly.
Check the rinse aid container and if it is
suitable for the type of mains water. If the
problem
assistance service.
Check if the pipe and the drain of the
dishwasher are obstructed and if the drain is
positioned too high up; refer to the connection
diagram.
consists, contact the technical
29