Start-Up Guide; Using Your New Dishwasher; Stopping Your Dishwasher; Dishwasher Loading - Whirlpool Gold GU2200 Guide D'utilisation Et D'entretien

Before using your dishwasher, remove all packaging materials. Read this entire Use and Care Guide. You will find important safety
information and useful operating tips.

Using Your New Dishwasher

1. Scrape large food soil and hard items (toothpicks or bones)
from dishes.
2. Properly load the dishwasher. (See "Dishwasher Loading.")
Make sure nothing keeps the spray arm(s) from spinning
freely.
3. Add detergent and check the rinse aid dispenser. Add rinse
aid if needed. (See "Dishwasher Use.")
4. Push door firmly closed. The door latches automatically. Run
hot water at the sink nearest your dishwasher until the water
is hot. (See "Dishwasher Efficiency Tips.") Turn off water.
5. Press the desired cycle and option selections.
Remove leftover food, bones, toothpicks and other hard
items from the dishes. It is not necessary to rinse the dishes
before putting them into the dishwasher. The wash module
removes food particles from the water. The module contains a
chopping device which will reduce the size of food items.
NOTE: If hard items such as fruit seeds, nuts, and eggshells
enter the wash module, you might hear chopping, grinding,
crunching, or buzzing sounds. These sounds are normal
when hard items enter the module. Do not let metallic items
(such as pot handle screws) get into the wash module.
Damage can occur.
It is important for the water spray to reach all soiled surfaces.

START-UP GUIDE

6. Press START/RESUME.
NOTE: If the door is opened during a cycle or the power is
interrupted, the Start/Resume indicator flashes. The cycle will not
resume until the door is closed, and Start/Resume is pressed.
IMPORTANT (on some models):
You can stop your dishwasher anytime during a cycle.
1. Open the door slightly.
2. Wait for the spraying action to stop. Then open the door all
Close the door and press START/RESUME to continue the cycle.
OR
Press CANCEL/DRAIN. A 2-minute drain starts.

DISHWASHER LOADING

Loading Suggestions

When the cycle starts, you will see a rotating pattern of lights
in the display window indicating that the unit is operating.
This pattern will continue for up to 6 minutes while the
multiple sensors check the incoming water temperature and
soil level on dishes and cookware. The sensors then
determine the ideal cycle for your dish load. After sensing is
complete, the display will show the number of minutes left in
the cycle and the cycle countdown will begin.
With the Adaptive Wash cycle (on some models), the pattern
occurs again in the Main Wash while sensors determine the
load size.
The cycle countdown pauses and the sensing light glows
while the dishwasher heats the water to a set temperature.
(See "Cycle Selection Charts.")
The time displayed does not include the time needed to heat
the water.

Stopping Your Dishwasher

the way, if needed.
Load dishes so they are not stacked or overlapping, if
possible. For best drying, water must be able to drain from all
surfaces.
Make sure pot lids and handles, pizza pans, cookie sheets,
etc., do not interfere with the spray arm rotation.
Run a rinse cycle to keep dishes moist if you do not plan to
wash them soon. Foods such as eggs, rice, pasta, spinach,
and cooked cereals may be hard to remove if they are left to
dry over a period of time.
7