Num'axes PIE1051 Guide D'utilisation page 33

Storage temperature
Operation humidity
Watertightness
Dimensions
Weight
Free mobile App
(Android/iOS)
10. Troubleshooting
10.1. The photos do not capture subject of interest
− Check the PIR detection sensitivity parameter setting. For warm environmental conditions, set the
sensor detection sensitivity to "High" and for cold weather use, set the sensor detection sensitivity to
"Low".
− Try to set your camera up in an area where no heat sources are in the camera's field of view.
− In some cases, setting the camera near water will make it take images with no subject in them. Try
aiming the camera over ground.
− Avoid setting the camera up on small trees that are prone to being moved by strong winds. Try to set
the camera on stable and immovable objects (i.e., large trees).
− Remove any limbs which are right in front of the camera lens.
− At night, the PIR sensor may detect beyond the range of the infrared flash. Reduce the detection
distance by adjusting the PIR sensor sensitivity.
− Rising sun or sunset can trigger the PIR sensor. The camera must be reoriented.
− If a subject moves quickly, it may move out of the camera's field of view before the photo has been
taken. Move the camera further back or redirect it.
10.2. The camera stops taking images/videos or won't take images/videos
− Please make sure that the memory card is not full. If the memory card is full, the camera will stop taking
photos/videos. To avoid such problem, check that the cycle recording function in activated (ON).
− Check the batteries to make sure that there is enough power left for the camera to work.
− Make sure that the camera power switch is in the ON position and not in the OFF or SETUP position.
− Please format the memory card with the camera before using it or when the camera stops taking
images/videos.
10.3. The night vision flash range doesn't meet expectations
− Please check to make sure the batteries are fully charged or have enough power left.
− Adjust the Night Mode parameter to "Maximum Range" for the best IR flash range.
− 1.2V Ni-MH rechargeable AA batteries can offer a much better IR flash range; alkaline batteries cannot
deliver enough amperage to power the illuminator consistently at night.
− To ensure accuracy and quality of the night time images, please mount the camera in a dark
environment without any obvious light sources.
PIE1051 - Indice D – Mars 2022
-30°C to +70°C
5% - 90%
IP66
128 x 96 x 76 mm
292 g (without batteries | 476 g (with batteries)
The PIE1051 trail camera can be remotely configured and triggered via the
mobile application.
Application's name: NumCam
33/104