Power Adaptor; Turn On The Camera - Num'axes PIE1051 Guide D'utilisation

3.3. Power adaptor

This camera can also be powered by an external DC adapter (12V/2A).
You can purchase a 12V external DC adapter at any time on www.numaxes.com.
We recommend removing the batteries when a power adapter is used.
DC power is recommended if the camera is used for security purposes.
4. Memory card
Using a memory card is required to operate the camera (SD card | Capacity from 4GB up to 32GB max |
Class 10 minimum).
You can purchase micro SD cards with adapter at any time at www.numaxes.com.
When the camera is in SETUP mode and no memory card is inserted, the LDC screen displays "No SD card".
Formatting the memory card in the trail camera before using it for the first time is strongly recommended,
especially when the card has been used in other devices. A memory card formatted in another device may
not be compatible.
Before inserting or removing the memory card, the camera must be turned off (switch in the OFF position).
Failing to do so may cause loss of or damage the files already recorded on the memory card.
When the memory card is full, the LCD screen indicates "Memory full".
5. SIM card
Before inserting or removing the SIM card (standard size), the camera must be turned off (switch in the
OFF position).
When the camera is in SETUP mode and no SIM card is inserted, the LCD screen displays "No SIM".
6. Attaching the antenna
Screw the antenna onto the socket on top of the camera. Make sure it is securely attached, but do not over-
tighten it.
7. Operation

7.1. Turn ON the camera

Put the switch in the ON position to turn on the camera (the LCD screen does not light up when you put the
switch to ON).
The indicator light located on the front of the product flashes 5 times before the camera gets into working
mode. This interval allows you to close the camera front cover and leave the monitored area.
Once in the ON mode, the camera will take photos or videos according to its current parameter settings.
NOTE: the camera comes pre-programmed with factory default settings (see tables on following pages).
7.2. Turn OFF the camera
Slide the switch to the OFF position to turn off the camera.
Please note that even in OFF mode, the camera still consumes power at a very low level. Therefore, please
remove the batteries if the camera will not be used for a long time.
PIE1051 - Indice D – Mars 2022 22/104