Num'axes PIE1051 Guide D'utilisation page 31

Other
Settings
Language
Date/Time
Date Type
Time stamp
Battery Type
Frequency
Cycle recording on
the memory card
Password
Reset
Update
Product information
PIE1051 - Indice D – Mars 2022
Programmable options (default settings in bold characters)
Français | English | Español | Deutsch | Italiano
Auto | Manual
− Auto
Time Zone
HH:MM
UTC +/- 00:00
The camera will synchronise the date/time after you enter your time zone
information.
− Manual
Date
20/03/2020
Manually set date/time.
NOTE: it is important to set the date and time to ensure some functions work
as expected (for example: time stamp on the photos, sending time of the daily
report, operation during defined time periods).
MM/DD/YY – US | DD/MM/YY – EU
ON | OFF
Select "ON" if you want the date and time of the image capture imprinted on
every photo. The current temperature, moon phase and user set camera ID
will also be imprinted on the still photos.
Alkaline | Ni-MH (nickel-metal hydride)
The device will perform better if you indicate the type of the batteries
installed in the camera.
50Hz | 60Hz
An improper setting may cause the camera screen to flicker.
OFF | ON
When the memory card will be full, the camera will continue to record
photos/videos by deleting the oldest photos/videos.
Select "OFF" then press OK to deactivate the cycle recording function.
OFF | ON
Select "ON" then press OK to enable password protection for your camera
(6 digits/letters).
No | Yes
Select "Yes" to reset the camera back to the factory default settings.
Insert the memory card with the updated firmware inside, then enter this
menu to update the camera by confirming "Yes" in the options.
This parameter shows the following information: Ver | IMEI | MCU | MOD
Time
15:55:00
31/104