Listo LF512-L2b Notice D'utilisation page 66

FAULT
The wash cycle produces unsatisfactory
results.
The wash cycle produces unsatisfactory
results.
As soon as water is being supplied to the
machine, leaks may occur.
There is no water visible in the drum
during washing.
There are washing powder residues on
the laundry.
There are grey spots on the laundry.
The spin cycle doesn't work or starts
later than expected.
(*) Go to the chapter on machine maintenance and cleaning.
(**) Go to the chapter on installing the machine.
V.1.0
POSSIBLE CAUSE
The laundry is too soiled for the
selected program.
Not enough washing product was used.
The drum is overloaded.
Hard water.
The laundry is too tightly packed in
the drum.
The end of the drain hose is too low in
relation to the machine.
This is not a fault. The water is located
in a part of the drum that is out of sight.
Particles of washing powder, that have
not properly dissolved, may appear as
white spots on the laundry.
There are untreated oil, cream or
ointment marks on the laundry.
There is no fault. The unbalance
detection system has been activated.
66
TROUBLESHOOTING
Use the program table to choose the best
program for the laundry.
Use the recommended quantity of washing
product shown on the packaging.
Check that the maximum capacity for the
selected program has not been exceeded.
Increase the amount of washing product,
according to the manufacturer's instructions.
Make sure that the laundry is evenly distributed.
Make sure that the drain hose is fitted at the
right height.(**)
.....................................................
Perform an extra rinse or clean the laundry with a
brush after drying.
Use the recommended quantity of washing
product shown on the packaging during the
next wash.
The unbalance detection system will attempt
to distribute the laundry evenly. The spin cycle
will start when the laundry has been properly
distributed. During the next wash, load the
laundry evenly.