Listo LF512-L2b Notice D'utilisation page 38

1. Before using the washing machine, remove the 4 transit bolts and rubber washers
located at the rear of the machine. Failure to comply with this requirement may
cause intense vibrations, a very loud noise and damage to the machine, and void
the warranty.
2. Loosen the transit bolts by turning them anticlockwise with a suitable spanner.
3. Remove the transit bolts by pulling them straight out.
4. Put the plastic plugs provided with the accessories kit in the holes left once the
transit bolts have been removed. Keep the transit bolts for use at a later date.
NOTE: Remove the transit bolts before using the machine for the first time.
Faults resulting from a machine being used with the transit bolts still in place are
not covered by the warranty.
A
djuSTINg The feeT
1. Do not install the machine on a surface (e.g. a carpet) that could prevent air from
circulating underneath.
For quiet and vibration-free operation, install the machine on a firm surface.
•
The level of the machine is adjusted using the adjustable feet.
•
Loosen the plastic lock nut.
•
2. To raise the machine, turn the feet clockwise. To lower the machine, turn the feet
anticlockwise.
Once the machine is level, re-tighten the locknuts by turning them clockwise.
•
V.1.0
/
AdjuSTINg The AdjuSTAbLe hOuSINg
38