Tripp-Lite PDUMNH15 Manuel Du Propriétaire page 3

2. Features
A B
Meter Select
LOAD (AMPS)
201006064 93-3049.indb 3
( continued )
Input Plug Adapter (Model PDUMNH20): The adapter converts a
NEMA L5-20P input plug to a NEMA 5-20P input plug.
NEMA 5-15R Outlets (Model PDUMNH15): During normal
operation, the outlets distribute AC power to connected equipment.
NEMA 5-15/20R Outlets (Models PDUMNH20 & PDUMNH30):
During normal operation, the outlets distribute AC power to connected
equipment.
Digital Load Meter (Ammeter, Models PDUMNH15 &
PDUMNH20): The total electrical current used by the PDU is displayed
on the digital meter in amperes.
Digital Load Meter (Ammeter, PDUMNH30): Displays the connected
load in amps. It can be set using the meter select switch to display the
PDU's total connected load (all outlets-both LEDs illuminated), or the
load carried by either the upper bank (Bank 1 LED illuminated) or lower
Bank 1
bank (Bank 2 LED illuminated) of outlet receptacles. If you press and
Bank 2
hold the mode selection switch
will display on the meter
"no address" will display, one letter at a time. If an IP address is
assigned, it will display one digit at a time, with dashes (-) representing
the dots (.) in the address.
Accessory Slot: An SNMP card is installed in the slot, allowing the
PDU to be configured, controlled and monitored remotely.
Factory Port: The port is reserved for configuration by factory
authorized personnel only. Do not connect anything to the port.
Output Circuit Breakers (PDUMNH30): Two circuit breakers (one
per outlet bank) protect connected equipment against dangerous system
overloads. If the total load on either of the PDU's outlet banks exceeds
20 amps, the associated circuit breaker will trip, cutting power to the
entire outlet bank. Reduce the load on the outlet bank by unplugging
some equipment; then press the circuit breaker in to restore power.
Cord Retentions Shelves (PDUMNH30, Optional): When installed on
the PDU, these shelves provide secure attachment points for connected
equipment power cords. Use the included cable ties to secure cords to
the shelf.
for 4 seconds, the unit's IP address
A
. Note: If no IP address is assigned (default),
B
3
10/6/2010 4:48:39 PM