PROUSER JADE Notice D'assemblage Et De Sécurité page 34

MOUNTING OF THE BIKE CARRIER ON CAR
The first step is to become familiar with the quick connector.
Plastic locking device
Quick connector adjustment screw
The quick connector consists of a case mounted to the bike carrier and a lever.
Using the lever, you can close and open the quick connector. Using the sliding
locking devise to lock the handle of the quick connector and finally lock the
complete quick connector with the key (mandatory during use!).
When mounting the bike carrier to the car, it is best that the car is parked
straight, the engine is turned off and the parking brake is activated. Make sure
that the tow ball is undamaged, clean and not greasy!
Open the lock of the plastic locking device with use of the supplied key. Turn the
key one quarter (key
stands now vertical).
Slide the plastic locking
device to the right (only
open red lock is visible
on the handle).
Release the quick connector by moving the handle in the
vertical position.
Position the bike carrier on the tow-bal
from the top. Press the handle of the
quick connector downwards (approx.
35-40kg) until it stops (handle will
stay stable in the horizontal position).
Green mark
Lock
Quick connector handle
34