Salter 1047 Manuel D'instructions page 3

Precautions
1. Clean exposed parts with a soft, slightly damp cloth. To remove stains, use a mild
soap. Never use detergents, excess water, treated cloths, harsh cleaning agents,
or sprays. Avoid contact with acids, such as citrus juices.
2. Do not tamper with the scale's internal components. Doing so will invalidate the
warranty on this unit and may cause damage. The scale contains no user-
serviceable parts.
3. Although your scale is designed to be maintenance-free, it contains sensitive
electronic parts. Avoid rough treatment. Treat it with care to ensurethe best
performance.
4. This scale is intended for home/consumer use only. It is not intended for
commercial or medical use.
5. This scale is designed to read weights up to 11 lbs/5 kgs/175fl.oz/5 liters. To prevent
damage, do not place more than 11 lbs/5 kgs/175fl.oz/5 liters on it.
6. Do not store scale where you store cleaning chemicals. The vapors from some
household products may affect the electronic components of your scale. Do not
store scale on its side.
7. This scale is an extremely sensitive weighing device. In order to prevent run down
of the battery, do not store anything on the scale.
8. Do not dispose of batteries in fire. Batteries may explode or leak. Do not mix old
and new batteries. Do not mix Alkaline, carbon-zinc (standard) or Nickel-
Cadmium (rechargeable) batteries. Remove the batteries if the scale will not be
used for a long period of time.
9. Overload Warning: Should "Err" appear on the display during a weighing, this
indicates that the maximum weighing capacity of the scale has been exceeded.
Remove the weight immediately; otherwise, permanent damage could occur.
Caution: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation. This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
3