Technogym Group Cycle Manuel De L'utilisateur page 7

Tuning the cadence receiver
Upon initial installation, in order to ensure that the cadence data is correctly displayed, the transmission mode must
be set - either belt or chain.
Upon purchasing the product, "chain" transmission is the default setting.
- Remove the batteries from the display.
- Insert the same batteries again while keeping any button depressed.
- Press the RETURN button; the receiver code is visualised.
- Press the RETURN button again; the default setting (i.e. "chain") is visualised.
- Press the INCREASE or DECREASE button to modify the parameter.
- Press the RETURN button to confirm the visualised parameter and exit.
If the cadence reading (RPM) is incorrect, verify that the display receiver and the transmitter have the same code.
If the codes match, replace the transmitter batteries.
If the data are still incorrect after replacing the batteries, proceed with tuning.
- Remove the batteries from the display.
- Insert the same batteries again while keeping any key depressed.
- Press the RETURN key and check the code appearing on the lower frame of the display. This code must match
the code printed on the transmitter.
- Press and hold the PLAY key; the display visualises code 0000.
- Set the same code as that appearing on the transmitter: press the INCREASE or DECREASE key to modify the
single digit; press the PLAY key to skip to the next digit.
If the data are still incorrect after completing this tuning procedure, contact the Technogym Technical Assistance
Service.
Wireless Console
0sm00698AA_GroupCycle Wireless Console_12gen.indd 7
chain belt
7
12/01/2011 14.47.25