Important - GLOBBER ONE K E-MOTION 4 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
5 - CHARGING
Low battery level: When the buzzer keeps ringing, E4 is in need of charge. When the
device is low on power (constant beeping), damage is likely to occur. This can impact
the service life of the battery.
Before charging, please read the following instructions:
- This appliance can be used by children aged 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and under the hazards involved.
- Children shall not play the appliance.
- Cleaning and user maintenance should not be made by children without
supervision.
- The charger is specific for lithium battery pack 14.4V and 2,6AH (Model No.:
4S1PSCOOTERM26).
- The battery charger has LED indicator: GREEN light indicates the battery is fully
charged or disconnected; RED light indicates the battery is in charging.
- Batteries are only to be charged by adults or by children at least 8 years old.
- Batteries are to be inserted with the correct polarity.
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
- Do not recharge non-rechargeable batteries. It may cause explosion.
- Battery chargers used with the toy should be regularly examined for damage to the
cord, plug, enclosure and other parts.
- In the event of such damage, they must not be used until the damage has been
repaired.
- Only use the charger supplied with your electric scooter. Using a charger other than
that supplied will invalidate the warranty.
- To optimise the performances and lifetime of your electric scooter battery, fully
charge the battery before using it for the first time and fully charge it once a month.
- Do not cover the battery compartment or the charger. There must be good
ventilation conditions at all times during charging.
- The charging environment must be clean. Ensure there are no traces of damp or
water in the electric socket before plugging in.
- Ensure you use a standard socket.
- Do not switch on the scooter during charging.
Warning. Do not use the battery or the device in the following cases:
1. The battery gives off a smell or the temperature inside the appliance is too high.
2. Leaks on the deck of the scooter.
6
If in doubt please contact Globber, contact@globber.com
Your electric scooter is delivered with a specific charger.
1. To charge your electric scooter, remove the waterproof cap from the port and plug
in the charger. For safety reasons, ensure the charging port is always dry before
starting to charge.
2. Plug the charger into a suitable power source.
3. When LED on the charger is red, the battery is charging.
4. When it switches to green, charging is complete. This takes approximately 3
hours. Stop charging when the LED turns green; charging the battery for too long
will reduce its lifetime.
1
2
The protective cover is used to protect the charging port from splashing water. Be
sure to replace the cap after each charging and before each use.

Important:

- The battery must only be removed and changed by an official Globber repair
center. No attempt should be made to dismantle the product and repair it yourself.
Any attempt to do so will invalidate the warranty.
- In case of battery leakage, do not touch it.
- Keep children away from the battery if it is leaking or displays any other problems.
- Batteries contain dangerous substances. Do not attempt to open the battery or to
insert any solid or liquid substance into the battery or into the body of the appliance.
- Only Globber is authorised to repair the appliance
- Using the battery is subject to authorisation by the local authorities.
3
4

Publicité

Table des Matières
loading

Table des Matières