GLOBBER ONE K E-MOTION 4 Manuel D'utilisation page 5

3 - ASSEMBLY
- Insert the handle bars into the hole at the front of the deck between the
two front wheels while paying attention to the direction of insertion.
- Ensure the spring loaded button pops out and locks the bar in place properly.
- E4 is provided with an adjustable T-bar which can be adapted to the child's height
(3 positions). The spring loaded button shall be in the hole when adjusting the
T-bar height.
- Make sure that for the lowest position of T-bar, the button is locked into the lowest
hole. Loosen the quick release clamp of the T-bar when adjusting. Tighten the
quick release clamp to secure T-bar after adjustment.
4 - MODE OF OPERATION AND USE
ON/OFF FUNCTION
- This scooter has a Kick Start function.
- To start, push your scooter forward; you will here a «beep» sound; you are now in
"ON" mode.
- Your E4 will turn off automatically after 1 minute of inactivity; you will here a
«beep» sound.
MODE
On the side, there is a switch button showing «1 / 2». This is for switching the
speed between mode 1 (6km/h) & mode 2 (10 km/h).
- Mode 1: Switch the Mode Button to "1", the scooter is set to the 1st speed mode,
and the maximum speed at this mode is 6km/h.
- Mode 2: Switch the Mode Button to "2", the scooter is set to the 2nd speed mode,
and the maximum speed at this mode is 10km/h.
- Kick scooter mode: you can simply ride on it like a normal scooter, even when it
runs out of battery.
START-UP
You are in a position to start:
To engage the motor, 3 actions are necessary.
1. Place your foot directly on the deck.
2. Push your scooter to reach a speed of 5km/h.
3. Press the accelerator button on the top of the T-bar.
Be aware that once your motor is turned ON, reducing your speed below 5km/h
does not automatically cut the motor, see paragraph STOP regarding the
instructions for stopping the motor permanently.
CHECK SPEED
To control the speed, you can simultaneously OR independently use the brake
located at the rear of the scooter (mudguard) and/or use the accelerator / throttle
button located on the right-side of the T-bar (press with your finger to accelerate;
release the pressure to slow down).
- Once the electric motor is engaged, it will accelerate until reaching the cruising
speed of 6 or 10 km/h, depending on which mode (1 or 2) you are using.
- You can control the speed with the electronic brake located at the rear: pressing
this brake automatically stops the motor. This system generates both mechanical
and electrical braking that reduce again the braking distance.
- WARNING! Engaging the brake (mudguard) automatically shuts off the motor and
only until you press the brake. If you release the brake, the motor automatically
engages again.
STOP
To stop the scooter completely, press the brake continuously for 3 seconds and
wait for the scooter to stop safely to get off the platform. At any time you can
remove your finger from the throttle button to automatically shut down the motor
for example in an emergency. The battery will automatically turn itself off when the
motor is not engaged for more than 60 seconds.
5