Lorex LNZ32P12 12X Manuel D'instruction page 10

4
Connecting the Camera
30W to each connected device, whereas standard PoE (class 3) ports only
provide up to 15W. In order to use this PoE+ rated camera without the in-
cluded power adapter, you must connect it directly to a compatible NVR (
LNR100 & LNR400 Series only) or a PoE+ switch on the same network as the
NVR. PoE+ switches are available for purchase on
(model #: ACCLPS241B).
Complete the following steps to connect the camera to the NVR over the LAN.
Step 1 of 2 — Option A: Connecting the camera to your local network
using an optional PoE+ switch:
INTERNET
Router
1. Connect an Ethernet cable of up to 300ft (91m) rated CAT5e or higher
(not included) from the LAN port on an external PoE+ switch (sold sepa-
rately on
ble to the PoE+ switch and to a power outlet or surge protector.
Note
Terminology may vary depending on the model of PoE+ switch you have.
2. Connect the camera to the PoE+ switch using the included Ethernet cable
(or a CAT5e Ethernet cable of up to 300ft (91m)). The PoE+ switch will
provide power and video transmission the same way as your NVR.
#LX400020; r. 1.0/16372/16530; en-US
www.lorextechnology.com) to your router. Connect the power ca-
NVR
Po E+ Sw itc h
www.lorextechnology.com
IP C a m e ra s
PTZ C a m e ra
6