Using The Machine - Garland FUM 250 MG-V19 Manuel D'instructions

Do not use the machine if it is damaged or
improperly adjusted.

7. USING THE MACHINE

Use this machine only for the designated
purposes. Using this machine for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
Don't start the machine in a room or
enclosed area. Exhaust gases, fuel vapors
and chain oil contain carbon monoxide and
dangerous chemicals. In case of a concentration of
gases produced by insufficient ventilation, eliminate
everything from the work area that prevents the flow
of clean air to improve ventilation and do not return to
work in the area unless you have properly ventilated
the area and be clear that the ventilation is sufficient
so that this concentration does not happen again.
Work only in daylight or with good artificial light. Do
not use this machine at night, with fog or with reduced
visibility that does not allow you to clearly see the
work area.
Avoid operating with the machine when the soil is
humid whenever possible. Take special care if you
use this machine in the rain or after it rains since the
ground will be slippery and you will be able to slip.
Don't rely solely on the safety devices of this machine.
It is necessary to pay attention to the possible
loosened or overheated parts of the machine. If you
detect any anomaly, stop the machine immediately
and check it carefully. In case of failure, take the
machine to the technical service for repair. Under no
circumstances should you continue working if you
notice that the operation is not correct.
Remember to always use the machine with clean
hands and no traces of fuel or oil.
Don't allow anyone to enter the work
perimeter. This perimeter of work must be
15 meters and is a dangerous area.
Never use this machine when it is on a ladder, in a
tree or any other unstable place.
It is necessary to turn off the engine when you move
between different work areas.
Never leave this machine unattended.
Be careful not to touch the hot parts of the
machine while the engine is running or after
use, such as the exhaust, the spark plug or the high
voltage cables.
Don't use accessories for this machine except those
recommended and approved by our company as such
use could cause severe damage to the user, people
close to the machine, and the machine itself.
Always follow the safety rules indicated in this manual.
7.1. FASTENING THE MACHINE AND GUIDING
This machine has been designed to be placed on the
back of the user as if it were a backpack.
To install the machine on the back, pass the arms
between the straps and place the machine on the
back so that it is correctly placed and with the blower
tube on the right side and so that the accelerator
controls can be used by hand left.
7.3. SPRAY
1. Start the machine following the instructions in
points 6.5.1 o 6.5.2
37/120
English