Turning Off The Engine - Garland FUM 250 MG-V19 Manuel D'instructions

English
Check:
- The machine completely and look for loose parts
(screws, nuts, etc.) and damages.
- That there are no fuel leaks.
- That the air filter is clean. Clean the filter if
necessary.
Tighten, repair or replace everything necessary before
using the machine.
Don't use any accessory on this machine other than
those recommended by us, as its use could cause
serious damage to the user, the machine and people,
animals and things close to the machine.
6.5. START UP AND STOPPING THE MACHINE
Warning: The pump of this machine must not work
without liquid. Never start this machine without having
the end of the hose with its strainer submerged in
liquid spray.
Before starting the machine, make sure that the spray
gun is closed. To do thise, close the gun by turning the
knob of the diffuser cone on the gun.
6.5.1. COLD-STARTING THE ENGINE
Place the machine on a flat and stable surface to start
it. Never try to start the machine when it is on your
back.
1. Place the air lever (8) in the position (CLOSE )
2. Pump the primer (17) of the carburetor 7 to 10
times several times to ensure that the fuel has
reached the carburetor.
3. Place the throttle lever
(5) in the intermediate
position.
4. Pull the starter rope
(9) until you hear an
explosion of the engine or starter motor.
5. Move the air lever (8) to the position (OPEN )
6. If the machine has not started (you only have heard
an explosion) pull the Starter rope again until it starts.
7. Let the engine warm up for a few minutes before
starting to use the machine.
6.5.2. STARTING WITH A WARM ENGINE
Place the machine on a flat and stable surface to start
it. Never try to start the machine when it is on your
back.
1. Place the air lever (8) in the position (OPEN ).
2. Place the throttle lever (5) in the intermediate
position.
3. Pull the starter rope (9) until you hear an
explosion of the engine or starter motor.
4. If after a few attempts the machine does not start,
follow the starting steps with the engine cold.

6.5.3. TURNING OFF THE ENGINE

Stop accelerating and
let the engine idle for a
few seconds.
Turn off the engine
by pressing the STOP
button
6.6. CHECKPOINTS AFTER START UP
It is important to pay attention to the possible
individual parts and the temperature of the machine.
If you detect any anomaly in the machine immediately
stop and check it carefully. In case of any malfunction
or problem take the machine for a service repair.
Under no condition should you continue to use the
machine if the operation does not seem appropriate.
36/120