Pride AAP4 Manuel De L'utilisateur page 12

High-Low Button
This switch toggles the scooter's speed between Hi and Low. Toggle the switch forward (Hi) to achieve the
maximum preprogrammed speed for the scooter. Toggle the switch rearward (Low) to achieve half the maximum
preprogrammed speed of the scooter.
Lights Switch (If Equipped)
This switch controls your Travel Scooter's lighting system. For all models, except 66 and 67, see fi gures 4 and 5.
 Toggle the switch forward to turn on the lighting system.
 Toggle the switch rearward to turn off the lighting system.
For models 66 and 67 (see fi gure 6):
 Toggle switch rearward to activate the puddle light.
 Toggle switch forward to activate the headlight.
 Return switch to center position to deactivate lights.
WARNING! Scooter users are required to use their lights when visibility is restricted—day or
night.
REAR COMPONENTS
The manual freewheel lever, anti-tip wheels, and motor/
transaxle assembly are located on your Travel Scooter as
shown. For all models, except Jazzy ZTS, see fi gure 8.
WARNING! Before placing your Travel
Scooter into or taking it out of freewheel
mode, remove the key from the key
switch. Never sit on a Travel Scooter
when it is in freewheel mode. Never put
a Travel Scooter in freewheel mode on
any incline.
Motor/Transaxle Assembly
The motor/transaxle assembly is an electromechanical
unit that converts electrical energy from your Travel
Scooter's batteries into the controlled mechanical energy
that drives the Travel Scooter's wheels.
Manual Freewheel Lever - Models AAP4, 29, 36, 336, 39, 40, 44, 40X, 44X, 40E, 44E, 40LX, 44LX,
49, 50LX, 50LXLIT, 53, 53HD, 54, 54HD, 54LX, 54LXLIT, 66, 67,
Whenever you need or want to push your Travel Scooter for short distances, you can put it in freewheel mode.
1. Locate the manual freewheel lever at the top right of the rear section.
2. Push forward on the manual freewheel lever to disable the drive system and the brake system. You may now
push your Travel Scooter.
3. Push the manual freewheel lever rearward to reengage the drive and the brake systems; this takes your Travel
Scooter out of freewheel mode.
WARNING! When your Travel Scooter is in freewheel mode, the braking system is disengaged.
Disengage the drive motors only on a level surface.

Ensure the key is removed from the key switch.

Stand to the side of the scooter to engage or disengage freewheel mode. Never sit on a

scooter to do this.
After you have fi nished pushing your Travel Scooter, always return it to the drive mode to

lock the brakes.
12
I I . Y O U R T R A V E L S C O O T E R
IDENTIFICATION KEY
1. Manual Freewheel Lever
2. Motor/Transaxle Assembly
3. Anti-Tip Wheels
Figure 8. Rear Components
73, 74, 83, and 84
Travel Scooter Series