Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
G) TROUBLE SHOOTING
SYMPTOM
1.
Tool does not fire, no noise
heard
2.
Air leaks from the cap when
the tool is connected
3.
Air leaks from trigger when
the tool is connected
4.
Tool fires without letting
fastener out
5.
Air leaks from nose when in
fired position with the trigger
pulled
6.
Driver stops too low
7.
Driver protrudes too much
from tool nose
8.
Bent fasteners
9.
Fastener not fully driven
10. Skipping
11. Too deep fastener
12. Other problems
PROBABLE CAUSE
1.a No air in the tool
2.a Damaged buffer
2.b Damaged cap O-Ring
3.a Damaged gasket or O-R
4.a Empty magazine
4.b Driver piston O-Ring
4.c Too low air pressure
5.a Worn out bumper
6.a Driver piston O-Ring
7.a Worn out bumper
8.a Wrong fasteners used
8.b Damaged driver tip
8.c Tool loaded incorrectly
9.a Too low air pressure
9.b Driver piston O-Ring
9.c Damaged driver tip
10.a Weak or broken pusher spring
10.b Weak or broken pusher spring
10.c Feeder piston O-Ring
10.d Damaged feeder piston spring
11.a Too high air pressure
11.b Worn out bumper
SOLUTION
1.a Check compressor and air lines
2.a Check and possible replacement
2.b Check and possible replacement
3.a Check and possible replacement
4.a Check magazine and reload
4.b Check and possible replacement
4.c Increase air pressure
5.a Check and possible replacement
6.a Check and possible replacement
7.a Check and possible replacement
8.a Introduce the right fasteners
8.b Check and possible replacement
8.c See loading instructions
9.a Round up to 0.5 bar (7,25 psig)
9.b Check and possible replacement
9.c Check and possible replacement
10.a Round up to 0.5 bar (7,25 psig)
10.b Check and possible replacement
10.c Check and possible replacement
10.d Check and possible replacement
11.a Round up to 0.5 bar (7,25 psig)
11.b Check and possible replacement
12. Contact the manufacturer
8
Publicité
Table des Matières
