Silverline 264895 Traduction Des Instructions Originales page 8

GB
Troubleshooting
Problem
Router will not operate
Router runs or cuts slowly
Makes an unusual sound
Excessive vibration
Heavy sparking occurs inside
motor housing
Fine Adjustment Knob (14) "clicks"
or not adjusting
8
Possible cause
No supply of power
Brushes worn or sticking
Switch is faulty
Motor components faulty or short circuited
Blunt or damaged cutter
Variable Speed Dial (5) set low
Motor is overloaded
Mechanical obstruction
Armature has shorted sections
Bent or damaged cutter
Brushes not moving freely
Armature short circuited or open circuited
Commutator dirty
Plunge Lock Lever (15) engaged
Reached end of adjustment range
Solution
Check that power is available at source
Disconnect power, open Brush Access Covers (4) & (20) .
and ensure brushes are not damaged or heavily worn
Contact an authorised repair agent
Contact an authorised repair agent
Re-sharpen or replace cutter
Increase variable speed setting
Reduce pushing force on router
Contact an authorised repair agent
Contact an authorised repair agent
Replace cutter
Disconnect power, remove brushes, clean or replace
Contact an authorised repair agent
Contact an authorised repair agent
Release Plunge Lock Lever
Reset Fine Adjustment Knob and set depth with Depth Stop Wheel (2)