Electric Start - CERTIFIED 060-1310-2 Guide D'utilisation

WARNING! Too many presses on primer
bulb may cause engine flooding. When
starting a warm engine, the primer
does not need to be used. If the engine
stops due to a lack of gas, refill then
press the primer 3-5 times.
Note: Do not use the primer or the choke if the
engine has been running and is hot. Excessive
priming may flood the engine and prevent it
from starting.

Electric Start

Note: Use only a UL-Listed, 16-gauge extension cord recommended for outdoor use that is not
longer than 50 feet (15m).
Connect an extension cord first to a power
source and then to the power socket of the
machine, and press the electric-start button
(Fig.15).
WARNING! Thoroughly inspect the
electrical cord before plugging it into a
power source. If the cord is damaged,
do not use it to start the machine.
Replace or repair the damaged cord
immediately. Contact the distributor or
local agent for assistance.
Important:
To prevent damaging the electric starter, Do not run the electric starter more than 10 times at
intervals of 5 seconds on, then 5 seconds off. If the engine does not start after this series of
attempts, allow the starter to cool for at least 40 minutes before attempting to start it again. If the
engine still does not start after the second series of attempts, take the machine to an Authorized
Service Dealer for service. Once started, disconnect the plug from the power supply and the starter.
Recoil Start
primer
electric-
start button
power socket
19
Fig. 13
Fig. 15