ASSEMBLY
CAUTION! Read INSTRUCTION MANUAL completely before operating this machine.
IMPORTANT! THIS SNOWBLOWER IS SHIPPED WITHOUT OIL OR GASOLINE IN THE ENGINE.
Your new snowblower has been assembled at the factory with the exception of those parts left
disassembled for shipping purposes. All parts such as nuts, washers, bolts, etc., necessary to
complete the assembly have been placed in the parts bag. To ensure safe and proper operation of
your snowblower, all parts and hardware you assemble must be tightened securely. Use the correct
tools as necessary to ensure proper tightness.
To remove snowblower from carton
1.
Remove loose parts included with snowblower.
2. Cut down two end corners of carton and lay end panel down flat.
3. Remove all packing materials except padding between upper and lower handle and padding
holding operator presence control bar to upper handle.
4. Roll snowblower out of carton and check carton thoroughly for additional loose parts.
Assembling the upper handle
1.
Position the ends of the upper handle on
the inside of the lower handle and align the
holes.
2. Insert the arc head bolt into the aligned
holes, with the bolt heads on the inside of
the handle.
3. Install the handle knobs on the bolts (Fig. 1)
and tighten the knobs securely.
4. Install and adjusting the control cable (see
Adjusting the Control Cable on pg. 14) .
Important: Ensure that the cable is routed
on the outside of the handle
Installing the Recoil Starter Handle
Install the recoil starter handle in the rope
guide as shown in Fig. 2.
13
Fig.1
Fig.2