CERTIFIED 060-1310-2 Guide D'utilisation page 16

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Checking and filling engine oil
As shown in Figs. 6 to 11.
CAUTION! The following procedures and
adjustments must be performed before
the engine is started. Do not attempt
to make any of these adjustments
while the engine is running.
CAUTION! To prevent engine damage,
the engine is shipped without oil or gas.
The engine must be filled with the
correct grade of oil and gas before
starting the engine. See pg 7.
NOTE! Running the engine with a low oil level will cause engine damage. It is recommend
that high detergent, premium quality 4-stroke engine oil is used. Using non-detergent oil
can shorten the engine's service life, and using 2-stroke oil will damage the engine.
CAUTION! Always use high quality detergent oil classified SAE 5W-30 oil or equivalent.
Never use additives with recommended oil. To prolong the life of the engine, it is important
that the oil is changed after the first 5 hours of use.
NOTE: To check the engine oil level, stop engine and place the snowblower on a level
surface.
1.
Remove the oil filler dipstick and wipe oil
from it with a clean cloth (see Fig. 6).
2. Insert the dipstick into the oil filler neck,
twist to close (see Fig. 7).
15
Fig.6
Fig.7

Publicité

Chapitres

Table des Matières
loading

Table des Matières