Brandson Equipment 303830 Mode D'emploi page 25

6. Usage
Keep the fan in an appropriate location and connect the device to a properly instal-
led 220-240V AC socket. Use the rotary switch on the back to switch on the device
and to control the speed: 0 = off, 1 = slow, 2 = medium and 3 = fast. To switch on
the oscillation, depress the pin at the top of the motor unit. If you do not want the
fan to oscillate, pull the pin out slightly.
Tilt angle
The tilt angle can be adjusted by loosening the knurled nut (7) and moving the
small knurled screw (4) by pulling or pushing the enclosure slightly forward or
backward. The limiting screw (2) ensures that the tilt angle is not too great and the
motor unit can tilt with the enclosure.
Important note: If the device is to be tilted independently, the screws (4) and (7)
must be tightened securely till the desired support is ensured!
4
7
The height of the fan can be adjusted using the height adjustment attachment (8).
8
25
English