Brandson Equipment 303830 Mode D'emploi page 24

Remove the mounting screws for the enclosure from the motor unit (Fig.1). Then
mount the enclosure onto the motor unit. (Figure 2) Make sure that the 4 holes
on the motor match the 4 holes on the back of the fan enclosure. Insert the
screws and tighten them.
Fig. 1 Fig. 2
Place the rotor blades on the motor unit and tighten the screw carefully. Make
sure that the rotor is properly positioned and screwed. The following figure shows
the correct assembly of the rotor.
Subsequently, mount the front fan enclosure on the rear enclosure and fasten
it using the metal brackets. Finally, tighten the small screw at the bottom of the
enclosure.
24
English