Brandson Equipment 303830 Mode D'emploi page 23

5. Assembly
Take the fan out of the package and check that the device and the installation
material are complete (see table). Please contact the vendor if any part is missing
or damaged.
Connect the metal base (10) with the coupling piece (11). Then screw it securely
using the mounting screws.
Remove the nuts and screws from the top side of the centre bar (3) and mount the
motor unit on the centre bar.
5
7
3
4
6
English
5
Remove the screws from the
top side of the centre bar and
the screws from the motor unit.
Place the motor unit on the
centre bar (3) and secure it
using the carriage bolt (5). The
next step is to mount the small
knurled screw (4) and the limi-
ting screw (6) as shown in the
figure.
Then secure the motor unit
with the lock nut (3) and the
carriage bolt (10).
23