Important Safety Instructions For Battery Packs - DeWalt DC410 Guide D'utilisation

632249-00,DC410 7/10/06 3:09 PM
• Always use side handle. Tighten the handle securely. The
side handle should always be used to maintain control of the tool
at all times.
• Clean out your tool often, especially after heavy use. Dust
and grit containing metal particles often accumulate on interior
surfaces and could create a hazard.
CAUTION: When not in use, place tool on its side on a stable
surface where it will not cause a tripping or falling hazard.
Some tools with large battery packs will stand upright on the battery
pack but may be easily knocked over.
CAUTION: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropri-
ate for the dust exposure. Direct particles away from face and body.
CAUTION: Use extra care when working into a corner or edge
because a sudden, sharp movement of the tool may be experi-
enced when the wheel or other accessory contacts a secondary
surface or a surface edge.
CAUTION: Wear appropriate personal hearing protection
during use. Under some conditions and duration of use, noise
from this product may contribute to hearing loss.
WARNING: Some dust created by power sanding, sawing, grind-
ing, drilling, and other construction activities contains chemicals
known to cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety equip-
Page 3
ment, such as those dust masks that are specially designed to fil-
ter out microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V............volts
Hz..........hertz
min ........minutes
......direct current
..........Class I Construction
..............(grounded)
..........Class II Construction .../min ........revolutions or
..............(double insulated)
BPM ......beats per minute
Important Safety Instructions for
Battery Packs
When ordering replacement battery packs, be sure to include cata-
log number and voltage: Extended Run-Time battery packs deliver
25% more run-time than standard battery packs. Consult the chart
at the end of this manual for compatibility of chargers and battery
packs.
NOTE: Your tool will accept either standard or Extended Run Time
battery packs. However, be sure to select proper voltage.
The battery pack is not fully charged out of the carton. Before
using the battery pack and charger, read the safety instructions
below. Then follow charging procedures outlined.
3
A ................amperes
W ..............watts
..............alternating current
n o ..............no load speed
..............earthing terminal
..............safety alert symbol
..................reciprocation per
..................minute