Searching Satellite - Travel Vision R6 Manuel De L'utilisateur

3.5

Searching satellite

After connecting the wiring as described in section 3.4, switch on your satellite receiver and television. Then the wiring as described in section 3.4, switch on your satellite receiver and television. Then the wiring as described in section 3.4, switch on your satellite receiver and television. Then
connect the control module to the antenna system by pressing it firmly into its socket.
On the display of the control module the following will be then shown: On the display of the control module the following will be
This last message will disappear within a few seconds, after which the system will present
this level, you can select the satellite of your choosing. this level, you can select the satellite of your
During its first usage, the system will preselect the Astra 1 satellite. The system will store and remember During its first usage, the system will preselect
previously selected satellite(s) and will show it ellite(s) and will show it on the display after startup.
List of preprogrammed satellites from which you can choose: List of preprogrammed satellites from which you can choose:
Satellite Position
Astra 1 19,2 E
Astra 3 23,5 E
Astra 2 28,2 E
Hotbird 13
Hellassat 2 39
Turksat 42
Eutelsat 9 9
to the antenna system by pressing it firmly into its socket.
TRAVEL VISION
RECREATION
FIRMWARE V****
within a few seconds, after which the system will present the satellite menu. At within a few seconds, after which the system will present
ASTRA 1 19.2°
TURN LNB TO 0
Satellite Satelli
Eutelsat 7 Eutelsat 7
SES 5 SES 5
Thor Thor
E Eutelsat 5 Eutelsat 5
E Eutelsat 12A Eutelsat 12
E Intelsat 907 Intelsat 907
E Telstar 12 Telstar 12
Hispasat Hispasat
BOOTING
∞
The system will store and remember
Position
7 E
5 E
1 W
5 W
12,5 W
27,5 W
15 W
30 W
page 9