Travel Vision R6 Manuel De L'utilisateur page 10

You will see a blinking ∞ symbol on the right-hand side of the display that indicates the status of the GPS location.
As long as it is blinking, the system is searching for the GPS location. When the symbol is continuously displayed,
the system has determined its GPS location.
We recommend that you wait with the selection of the desired satellite until the system has determined the GPS
location. The time needed for the determination of the GPS location is approximately 1 minute (see also next
remark).
After determination of the correct GPS location, the system will be able to find the satellite more quickly. It also
provides for the opportunity to set the correct LNB to ensure position optimal reception.
The correct position of the LNB is shown on the display for each satellite, which may differ per selected satellite.
When the GPS location has not been found (yet), by default this position will be 0.
Remark:
In the case of a weak GPS signal, it might not be possible to determine the location, in which case the system can
be used as normal. However, finding the satellite will take longer and the optimal position of the LNB will not be
provided. If the GPS signal improves during satellite search, then the system will adjust automatically.
Select the desired satellite, read off the corresponding LNB position from the display, and bring the LNB into this
position by turning the LNB holder accordingly (see images below).
After you have correctly positioned the LNB, press the Start button (1) to begin searching for the satellite.
You can browse through the preprogrammed satellites step by step.
By means of the arrow buttons located on the control module (buttons
4 and 5), For each satellite, the correct LNB position is shown on the
display.
LNB in position 0
Page 10