Satellite Found, But Not All Channels; Error No 24V Connected; Error Voltage Low; Error During Software Update - Travel Vision R6 Manuel De L'utilisateur

7.3

Satellite found, but not all channels

Check whether your subscription or smart cart is still valid.
7.4

Error No 24V connected:

The AC power adapter is connected or is defective
The power inserter may be connected the wrong way. Check the connection and switch the power
supply on and off. Reinstall the control module. See also Section 8.2, Troubleshooting, and the FAQ.
7.5

Error Voltage Low:

The voltage is too low for the system to operate
If you are using an external satellite connection, connect the 15 metre coaxial cable directly to the power
inserter. See also Section 8.2, Troubleshooting, and the FAQ
7.6

Error during software update:

Repeat the software update procedure
7.7 Error during software update:
Check if the software has been correctly stored on the USB flash drive.
7.8 Error during software update:
Insert the USB flash drive once more.
7.9

Error messages: calibration failed, error azimuth adjustment, error elevation adjustment

ERROR DURING
CALIBRATING
Check that there are no obstructions which hinder the rotation or alignment of the dish. Remove the
control module from the antenna unit and reinsert it again.
ERROR:
No 24V CONNECTED
ERROR:
VOLTAGE LOW
E:ERROR DURING
UPGRADE
E:FIRMWARE NOT
FOUND
E:USB DISK NOT
FOUND
ERROR AZIMUTH
ADJUSTMENT
ERROR ELEVATION
ADJUSTMENT
page 15