Control Module; Choosing A Setup Location; Positioning The Tripod - Travel Vision R6 Manuel De L'utilisateur

2.1

Control module

The control module has 4 functions:
•
Actuate The build-in motors and electronics drive the system
•
Control Sends commands to the antenna dish, e.g. satellite choice, parking, etc...
•
Display indicates the system's status on the display
•
Update Replaces or updates Replaces or updates the software
3.1

Choosing a setup location

Choosing a setup location
Several factors must be considered when deciding
•
The surface on which the ante surface on which the antenna will be positioned should be reasonably flat.
•
The ideal location is a place where there is an unobstructed view in all directions. The ideal location is a place where there is
•
When the view is obstructed, choose a location with is obstructed, choose a location with an unobstructed view in the direction of the desired
satellite. This means that there should be no satellite. This means that there should be no obstructions such as trees, trailers or RV's
3.2

Positioning the tripod

in motors and electronics drive the system
commands to the antenna dish, e.g. satellite choice, parking, etc... commands to the antenna dish, e.g. satellite choice, parking, etc...
the system's status on the display
be considered when deciding on the location of where to set up the system:
After choosing a suitable setup location, you can unfold and
position the tripod. Ensure that the legs are
that the system will stand in a stable and rigid
Additionally, the legs can be secured by
pegs. Place the tripod on a surface that is
The surface does not have to be perfectly horizontal, but the
more the unit is leveled, the quicker the system will
satellite.
Control panel buttons:
Start (system starts search
1.
Park (system places itself in the parked position) Park (system places itself in
2.
3. Enter (select)
4. Arrow up
5. Arrow down
6. Escape (one step back)
7. Menu
Stop
8.
USB port
9.
A USB port is located at the back of the control A USB port is located at the back of the control
module to carry out software updates module to carry out software updates
(see section 4.2 on how to update the software)
the location of where to set up the system:
trees, trailers or RV's, buildings, etc...
sure that the legs are fully extended so
stable and rigid position.
, the legs can be secured by means of the supplied
the unit is leveled, the quicker the system will locate the
searching for satellite)
how to update the software)
in the direction of the desired
cation, you can unfold and
that is as flat as possible.
ectly horizontal, but the
Page
6