Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Using the accessory tool (Fig. L–O)
•
Press the main handle/wand release button
the main handle/wand from the chassis
•
Free the hose connector
port
6
as shown in Figure L.
Fig. L
5
6
•
Press the lift away canister release button
and remove the lift away canister
as shown in Figure M.
Fig. M
5
•
Connect the hOSE CONNECTOR
TOOL HOSE PORT
ENSURING THAT THE LATCH
15
CLICKS SECURELY INTO PLACE AS SHOwn in Figure N.
Fig. N
to free
17
23
.
3
from the main body hose
17
23
4
3
41
to release
5
from the chassis
23
41
23
TO THE ACCESSORY
3
16
4
3
16
15
•
Extend the crevice tool
19
clicks in place.
•
To retract the crevice tool
tool release button
16
allowing it to return to its
normal position.
Fig. O
19
Using the 3 in 1 Accessory tool (Fig. P)
•
The 3-in-1 accessory tool
-
Brush mode.
-
Small crevice mode.
-
Upholstery mode.
•
The 3-in-1 accessory tool can be fitted either directly to
the hose connector
3
or to the pet crevice tool
shown in Figure P.
Fig. P
18
18
Cleaning and emptying the vacuum
WARNING:
Never use the vac without its filter.
nOTE: The filter is re-usable, do not confuse it with a
disposable dust bag, and do not throw it away when the
product is emptied. We recommend that you replace the
filter every 6–9 months depending on frequency of use.
There are two methods of cleaning the canister, a quick
empty method and a thorough clean method.
To empty the dust canister (Fig. L, M, Q, R)
•
Press the life away canister release button
and remove the lift away canister
as shown in Figure M.
English
as shown in Figure O, until it
19
press the crevice
16
has three configurations.
18
19
as
3
19
Projectile/Respiratory Hazard:
41
to release
5
from the chassis
23
7
Publicité
Table des Matières
