Individual Parts Of The Wok Burner; Operating The Appliance - Gaggenau VG 231 220 CA Notice D'utilisation

Individual parts of the wok burner

Ensure that the individual parts of the wok burner are
fitted in the correct position and are straight; otherwise,
this may result in ignition problems or problems during
operation. Fit the burner head such that the
thermocouple is positioned in the corresponding recess
on the burner head. The lug on the burner ring must
engage in the corresponding recess on the burner head.
Note: If the burner parts are fitted at an angle, the
appliance will not work.
(
Burner cap
0
Burner ring
8
Burner head
@
Thermocouple
H
Ignition plug

Operating the appliance

O p e r a t i n g t h e a p p l i a n c e
N otes
Only use the accessories specified. Do not line the
▯
stainless steel recess (e.g. with aluminum foil).
Do not cover the ventilation openings on the back of
▯
the control panel.
The burner and ignition plug must be clean and dry.
▯
Only light the burner if the pan supports and all
▯
burner parts are correctly fitted.
To ignite the burner, firmly press the control knob
▯
down as far as possible and hold it there, then turn it
to the required position.
Once ignited, press and hold the control knob for
▯
approx. 2 to 4 seconds to enable the heat sensor that
opens the gas flow to heat up first.
If the flame does not ignite within 2 to 4 seconds, turn
▯
the control knob anti-clockwise to the lowest setting
and, once ignited, turn it back to the highest setting. It
can often be quicker to ignite the burner in the lowest
setting because different gases have different ignition
characteristics.
Do not touch the ignition plug while the gas appliance
▯
is being lit.
It is important to keep the appliance clean. If the
▯
ignition plug is dirty, this may cause ignition problems.
Clean the ignition plug regularly with a small, non-
metallic brush. Take care to prevent the ignition plug
from suffering any heavy knocks.
Operating the appliance
en-us
13