Lanaform Fidji Mode D'emploi page 5

Do not use perfume or synthetic es-
sences as these could damage the
device.
Unplug the device before cleaning it.
Do not wash the entire unit with wa-
ter and do not immerse it in water.
Consult the cleaning instructions in
these instructions for use.
Never scrape the transducer with a
hard tool. Consult the cleaning ins-
tructions in these instructions for use.
The device should be used preferably
for 30 minutes at a time, but can be
used several times a day if you wish.
Make sure you never empty the wa-
ter through the exhaust vent as this
would damage the diffuser. Empty the
water in the direction indicated by the
arrow (Fig. 1 point 6).
This device is not intended for use
by people, including children, with
reduced physical, sensory or men-
tal capabilities, or people with lack
of experience or knowledge, unless
someone responsible for their safety
can supervise or instruct them before-
hand on how to use the device. Child-
ren should be supervised to make sure
they do not play with the device.
Use this device only for its intended
purpose, as described in these instruc-
tions for use.
INSTRUCTIONS FOR USE
Features
•
•
E-IM-Fidji-001-2.0.indd 5
70 ml capacity
8 hours of continuous diffusion
EN
FR NL DE IT PL CS SK SL HR LT
• Lights with constantly changing
or permanent colours
• Easy-to-fill water reservoir
• Automatically switches off
when there is not enough water
remaining in the reservoir.
Instructions for use
Place the Fidji in the room half an hour
before turning it on to allow it to ad-
just to room temperature.
Check that the diffuser is clean.
Remove the cover from the base of the
diffuser (Fig. 2, point 1).
Fill the reservoir with no more than
70 ml of clean water (Fig. 3). The tem-
perature of the water should not ex-
ceed 40 °C.
Pour a few drops of essential oil into
the reservoir (Fig. 4).
Replace the cover on the filled water
reservoir (Fig. 2, point 2).
With dry hands, connect the micro
USB cable to the diffuser (Fig. 5, point
2), then connect the other end to your
computer or to a mains plug using a
5V USB mains adapter (not supplied)
(Fig. 5, point 3).
Press the button to switch on
/
on off
the device (Fig. 5, point 1). The diffuser
has several functions:
1 Press once to start diffu-
sion and colour-changing
atmospheric light effects.
2 Press a second time to set the
atmospheric colour of your
choice. Press when you see
the light colour you want.
5
/ 60
23/05/2018 11:45:27