Troubleshooting - Kärcher NT 45/1 Tact Te Ec Mode D'emploi

Cleaning the electrodes
 Release and remove the suction head.
 Clean the electrodes.
 Insert and lock the suction head.

Troubleshooting

Suction turbine does not run
 Check cables, plugs, fuse, socket and
electrodes.
 Turn on the appliance.
Suction turbine turns off
 Empty the container.
Suction turbine does not start again
after the container has been emp-
 Turn off the appliance and wait for 5
seconds, turn it on again after 5 sec-
onds.
 Clean the electrodes as well as the
space between the electrodes.
Suction capacity decreases
 Remove blockages in the suction noz-
zle, suction tube, suction hose, or flat
pleated filter.
 Exchange the paper filter bag.
 Ensure the filter cover properly locks
into place.
 Clean or replace the membrane filter
(special accessory).
 Replace the flat pleated filter.
tied
Dust comes out while vacuuming
 Check for proper installation of the flat
pleated filter.
 Replace the flat pleated filter.
Automatic shut-off (wet vacuum
cleaning) does not react
 Clean the electrodes as well as the
space between the electrodes.
 Continuously check the filling level in
case of non-conductive liquid.
Automatic filter cleaning is not
working
 Suction hose is not connected.
Automatic filter cleaning cannot be
switched off
 Inform Customer Service
Automatic filter cleaning cannot be
switched on
 Inform Customer Service
13
English