To verify the programmation press the
to "P" lights up.
Note:
there is no regulation in minutes.
The shut-down time can not be lower than the starting time.
If the starting time and the shut-down time coincide the appliance goes into stand-by.
Window sensor settings:
1.
Press the
2.
Press the
shows" 23" (the default temperature) press the
the
button to increase or decrease temperature. The
lights next to these symbols
up.
If the temperature goes down too quikly the program switches the appliance to
stand-by mode: press the
to disable the program: the corresponding light will shut-down and the appliance
works with the previous functions.
3.
When both "window sensor settings" and "weekly program" are active the
appliance is on when both functions are active and is off if the functions are
inactive.
To switch off the appliance, press the "
power outlet.
CLEANING AND MAINTENANCE
Attention: before cleaning the appliance, switch off, unplug and wait for before it
has completely cooled down.
To clean the body use a soft damp cloth; do not use abrasive products.
Do not submerge any part of the heater in water or other liquids; if this should
happen, do not put your hands into the liquid, firstly remove the plug from the
power socket. Carefully dry the appliance and check that all the electrical parts
are dry: if in doubt, contact professionally qualified personnel.
From time to time clean the grid to remove fluff, dust or other deposits, to
improve the performance. Use a vacuum cleaner or a cloth.
If you decide not to use the appliance any more, we recommend making it
inoperative by cutting the power cord (after making sure you have disconnected
the plug from the socket) and make dangerous parts harmless if children are
allowed to play with them.
button: the appliance switches on.
button to set the temperature: the display
button to start the appliance. Press the
/
/
, °C, "I"e"II" should light
" button, then eject the plug from the
23
/
buttons: the light next
or
button