Bimar HP090 Notice D'instructions page 20

Is the timer when the appliance is on, every time you
press the button it extends the working time of the
appliance by one hour (max 12h), when the time runs
out the appliance switches to off automatically. On
the display appears the selected time next this simbol
, beside the one of the active functions. To
disable the timer press the button repeatedly until "
00 " appears. The picture shows the timer with "8
hours" selected.
The timer is also a start programmer when the
appliance is in stand-by: every time the button gets
pressed the timer adds one hour of stand-by, when
the time runs out the appliance starts automatically.
The remaining time (in hours) is written on the display
until the time runs out and the appliance starts to
work. .

The buttons
49°C); the default temperature is 23°C and it increases if you press the
and decreases if you press the
between the selected temperature nad the outside temperature and it can vary
between 1000W, 2000W or "only ventilation" mode: when the selected
temperature is reached the appliances stops automatically. If the appliance is in
Stand-by and the temperature decreases 2°C from the selected temperature the
program starts the appliance automatically. If the selected temperature is lower
than the room temperature the appliance will not work. To leave out the room
temperature press the
this mode without temperature limit. The symbol °C disappears from the display
and the symbol "- -" appears. The appliance will work for 12 hours at the
selected power, then it will work for 30 seconds as "only ventilation" and then go
into stand-by.

The button on the remote control confirms the selected temperature or the
selected time.
Weekly program (only remote control)

The button on the remote control: shows the "window sensor" that checks if
the temperature goes down by 5-10°C in less than 10 minutes and if it does it
stops the appliance for 30 minutes and then goes in stand-by.

The button on the remote control: chooses the days of the week (d1-d7).
and on the remote control: define the temperature (10-
button and select power I or II: the appliance works in
button. The power depends on the difference
20
button