Bimar HP090 Notice D'instructions page 17

by pulling the cord.
 All repairs should be made by a competent qualified
electrician. Any faulty appliances should be returned to this
service.
 The grate does not give complete protection for children or
people with reduced pshisical capabilities.
INSTALLATION
 After removing the packing materials, check the integrity of the heater; if you are
unsure, do not use it and ask for qualified professional help. The packing materials
(plastic bags, polystyrene foam, nails, etc.) must be kept out the reach of children
because they are potential sources of danger.
 Before connecting the appliance, check that the voltage shown on the data plate
matches that of your mains. In the event of incompatibility between the electric
outlet and the plug of the heater, have the outlet replaced with another more suitable
by professionally qualified personnel, who will make sure that the section of the wires
of the outlet is appropriate for the absorbed power of the heater. Check that the
mains are not connected equipment; high absorption to prevent overloading and fire
risks. Check that the mains are not connected equipment; high absorption to prevent
overloading and fire risks. In general, the use of adapters or extension cords is not
recommended; if their use is indispensable, they must conform to existing safety
standards and their current capacity (amperes) must not be less than the maximum
of the heater.Attention: before using the appliance remove the detachable coupon
to stick the handle.
 The heater must only be used if secured to a wall: the wall must be flat, smooth, very
stable (as the appliance could tip over) and heat resistant. The heater must be
positioned in a way that: -The air exit grill has a minimum of free space of 100 cm.,
while to the sides, the free space must be at least 40 cm.
 Position the fan heater far from other sources of heat, inflammable materials
(curtains, carpets, etc.), inflammable gases or explosive materials (spray cans) and
from materials that can deform on exposure to heat.
 If the appliance is fitted to a wall, the same must be made of masonry and/ or of heat-
resistant material (not of wood or synthetic material which rapidly heats up), care
should be taken not to fit panels where water pipes or electrical wiring might be
embedded in the walls; follow the indications below for installation:
17