LaserLiner ThermoCamera-Vision Mode D'emploi page 37

10.0
Activate / deactivate measurement points
Up to three measurement points can be set at one time. They can be assigned measurement-speci c
parameters as well as the following properties: maximum temperature, minimum temperature, manual
positioning.
Point 1
Point 2
Point 3
10.1
Measurement points / function
Point 1
Point 2
Point 3
10.2
Measurement points / parameters
For each measurement point, you can either use the previously set general parameters (see chapter 8)
or de ne different parameters.
Point 1
Point 2
Point 3
! To set values that deviate from the general parameters, deactivate the check for the general
parameters in this menu.
ThermoCamera-Vision
Point 1
Point 2
Point 3
Mode Point 1
Manual
Max
Min
Settings Point 1
Use global para
Emiss:
0.93
Distan:
2 m
Offset:
0.0 °C
activated deactivated
Point 1
Point 2
Point 3
activated deactivated
Manual
Max.
Min.
Manual: The measurement
point position is determined by
moving it on the touch screen.
Min. / Max.: The measurement
point is shown in the thermo-
gram with the minimum/
maximum temperature.
Settings Point 1
Use global para
Emiss:
0.93
Distan:
2 m
Offset:
0.0 °C
GB 37