Functional Description - Porter Cable PC70THD Manuel D'instructions

fUNcTIoNAl DeScRIPTIoN

figure A
1. Variable speed switch
2. Lock-on button
3. Forward/reverse slider
4. Two-gear selector
5. Drilling mode selector
6. Chuck
7. Chuck key & strap
8. Depth stop rod
9. Side handle
Safety Warnings and
Instructions: Drills
WARNING:
1. Hold drill firmly with one hand on the
grip and the other hand on the side
handle as shown in figure B.
2. When attaching accessories in the
drill chuck, tighten with all three holes
to prevent slippage.
WARNING:
Always expect the stall. Grip the drill firmly with both hands to control the twisting action
and prevent loss of control which could cause personal injury. If a stall does occur,
release the trigger immediately and determine the reason for the stall before re-starting.
Assembly
WARNING:
before assembly, make sure that the tool is
switched off and unplugged.
Attaching the side handle - (figure c)
If your drill is equipped with a side handle, it
must be installed properly to control the drill
• Turn the grip counterclockwise until you can
slide the side handle (9) onto the front of the
tool as shown.
• Rotate the side handle into the desired
position.
Drill may stall (if overloaded or improperly used) causing a twist.
To reduce the risk of injury,
a
6
8
9
7
B
c
5
5
3
4
1
2