Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING
drilling, and other construction activities contains chemicals known to the state
of california to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and wash
exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING
cause serious and permanent respiratory or other injury. Always use NOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles away
from face and body.
Symbols
The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ...direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
...............Read instruction manual before use
................Use proper eye protection
BPM ............beats per minute
• When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting
in loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gauge. The smaller the gauge number, the heavier the cord.
Volts
120V
240V
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More
Than
0
6
10 -
12 -
:
Some dust created by power sanding, sawing, grinding,
:
Use of this tool can generate and/or disperse dust, which may
Minimum Gauge for cord Sets
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
Not more
Than
-
6
18
-
10
18
12
16
16
14
A ...................amperes
W ..................watts
or AC .......alternating current
n o .................no load speed
..................earthing terminal
................safety alert symbol
.../min or rpm...revolutions or
...................Use proper respiratory protection
................. Use proper hearing protection
Total length of cord in feet
26-50
51-100
51-100
101-200
American Wire Gauge
16
16
16
14
16
14
12
Not Recommended
4
reciprocation per minute
101-150
201-300
14
12
12
Publicité
Table des Matières
