Functional Description - Porter Cable PCC607 Manuel D'instructions

pack in locations where the temperature
may be reach or exceed 105°F (40˚C)
(such as outside sheds or metal
buildings in summer).
WARNING
:
Never attempt to open the
battery pack for any reason. If battery pack
case is cracked or damaged, do not insert
into charger. Do not crush, drop or damage
battery pack. Do not use a battery pack or
charger that has received a sharp blow,
been dropped, run over or damaged in any
way (i.e., pierced with a nail, hit with a
hammer, stepped on). Damaged battery
packs should be returned to service center
for recycling.
WARNING
:
Fire hazard. Do not
store or carry battery so that metal
objects can contact exposed battery
terminals. For example, do not place
battery in aprons, pockets, tool boxes,
product kit boxes, drawers, etc., with loose
nails, screws, keys, etc. Transporting
batteries can possibly cause fires if the
battery terminals inadvertently come in
contact with conductive materials such
as keys, coins, hand tools and the like.
The US Department of Transportation
Hazardous Material Regulations (HMR)
actually prohibit transporting batteries in
commerce or on airplanes (i.e., packed in

FUNCTIONAL DESCRIPTION

Figure A
1. Trigger Switch
2. Forward/Reverse Button
3. Chuck Collar
4. Hex Quick-Release Chuck
5. Battery
6. Battery Release Button
7. Battery Fuel Gauge
8. LED Work Light
9. Bit Tip Clip
This product uses the batteries and chargers listed below.
20V Max* Lithium-Ion Batteries: PCC680L, PCC681L, PCC682/PCC682L, PCC685L
20V Max* Lithium-Ion Chargers: PCC690L, PCC691L, PCC692/PCC692L, PCC695L, PCC699L
suitcases and carry-on luggage) UNLESS
they are properly protected from short
circuits. So when transporting individual
batteries, make sure that the battery
terminals are protected and well insulated
from materials that could contact them and
cause a short circuit. NOTE: Li-Ion
batteries should not be put in checked
baggage.
NOTE: Do not store the battery packs in
a tool with the trigger switch locked on.
Never tape the trigger switch in the ON
position.
NEVER force the battery pack into the
charger. DO NOT modify the battery pack
in any way to fit into a non-compatible
charger as battery pack may rupture
causing serious personal injury.
Storage Recommendations
1. The best storage place is one that is
cool and dry away from direct sunlight
and excess heat or cold.
2. Long-term storage will not harm the
battery pack or the charger as long as the
battery is not depleted.
3
4
1
7
9
6
6
2
8
5