Setting Up The Product - afriso WaterSensor eco Mode D'emploi

6 Mounting
6.1

Setting up the product

RISK OF STUMBLING
Only place the product where persons cannot stumble over it.
Failure to follow these instructions can result in injury or equipment dam-
age.
 If you intend to mount multiple products, start by creating a mounting plan
with the appropriate mounting locations. Then label the products with
numbers or the corresponding mounting location to help avoid confusion
of mounting locations.
1. Position the product as close as possible to a location where water may
leak.
2. Place the product onto the ground with the fibre disks pointing down.
3. Take into account the gradient of the floor and the possible direction of
flow of the leaking water.
4. Remove water absorbing materials on the floor, for example carpets.
6.1.1 Fastening the product with foam rubber
You can fixate the product on slippery surfaces with the enclosed foam
rubber strip.
Mounting
CAUTION
WaterSensor eco
EN
12