Assembling The Rack - NewAge Products BOLD 3.0 Serie Mode D'emploi

Assembling The Rack

Parts required
9 x Hex Head Tapping Screw 3 x Rack Hanging Bracket
1 x Cordless Power Drill 1 x Adjustable wrench
Start by placing the left side panel
2
on its side (Item 7). Make sure the 2
bottom holes are facing you.
7
Secure Item 9 to the side panel using
4
a M6 Flat washer (Item 1) and a hex
bolt(Item 3).
23 X Washer 12 X Hex Bolt
1 x Socket driver wrench
3
1
Remove all items from packaging and
1
ensure all parts have been provided.
Take Item 9 and align it to the bottom
slots and hole. Make sure the two
3
holes at the bottom of the beam are
facing you as shown in image below.
Take Item 11 and repeat steps 3 and 4
5
respectively.
9
11
9